Appliance Resolve
LG dishwasherLast reviewed July 31, 2026

LG dishwasher IE error

The dishwasher detected insufficient water in the tub during the fill period. LG identifies IE as a no-water or water-inlet error on supported dishwashers.

Applies to: LG dishwashers that display IE. Confirm that the display is IE and not E1, because meanings differ.Confidence: Brand-level official guidance. Confirm your exact model.
Safety statusOwner-safe checks

Cancel the cycle and inspect the external water supply. Keep the dishwasher off while checking under the sink.

Plain-language answer

What the IE code means

The dishwasher detected insufficient water in the tub during the fill period. LG identifies IE as a no-water or water-inlet error on supported dishwashers.

This code points to a problem category. It does not prove that a specific internal part has failed.

Do these in order

Safe checks to try

  1. 1

    Confirm the dishwasher water valve is open

    Check the shutoff valve under the sink and open it fully if it was closed.

    What to look for: A recently installed or serviced dishwasher may have a closed valve.
  2. 2

    Inspect the visible inlet hose

    Look for a kink, pinch point, or damaged section under the sink.

    What to look for: Do not use the dishwasher if the hose leaks.
  3. 3

    Check household water pressure symptoms

    Confirm that nearby faucets have normal water flow.

    What to look for: A broader plumbing issue may affect the dishwasher.
  4. 4

    Retry once

    After correcting an external supply issue, run a short cycle.

    What to look for: A returning IE code needs model-specific service.

Stop and arrange service when

Stop if the inlet hose or valve leaks, water is near electrical connections, the dishwasher must be pulled out, or the IE code returns after the external checks.

Common questions

LG dishwasher IE error: FAQs

Will resetting the appliance clear this code?

A reset may clear a temporary display state, but it does not correct a blocked hose, closed valve, installation issue, leak, or failed component. If the code returns, stop repeating resets and address the cause.

Does this code prove that a part has failed?

No. An error code identifies a condition the control detected. Visible supply, drainage, installation, and load conditions should be checked before a part is diagnosed.

Can I keep using the appliance when the code returns?

Do not keep running repeated cycles. Stop immediately for leaks, water near electricity, burning odor, smoke, damaged hoses, or repeated breaker trips, and arrange model-specific service.

Source provenance

Official sources

These links support the code meaning and safe first checks. Use the manual for your exact model when instructions differ.

LG dishwasher IE error helpOfficial IE meaning and fill guidanceLG manuals and documentsModel-specific manuals and installation guides
Researched and reviewed by Appliance Resolve EditorialLast reviewed July 31, 2026Review standards